These directions focus on functionality and construction of the self-faced patch pocket.

As a general rule, patch pocket dimensions are the size of your hand plus ¾” – 1 ½” (2-4cm) all around for ease.
With right sides together, fold the hem to the outside along the fold line.  Stitch ends.  Trim seams.
If desired, topstitch or use a decorative stitch along top edge of pocket before applying to garment or leave plain.

Place pocket on garment matching placement lines and markings.  Edgestitch or topstitch pocket in place, leaving top edge open.
Tip: To hold pocket in place while sewing, us a thin strip of lightweight fusible webbing. Place it under the sides and bottom edge of the pocket and gently press to secure it.
After cutting the pocket of your desired shape and fabric, mark the hem fold line either with a fabric marking pen or by clipping on either side of the hem line.
Finish upper edge of pocket.
For pockets with rounded corners, ease stitch (baste) the curved edges 3\8” (1 cm) from raw edges and notch the seam allowance around the curved edge.
Turn upper edge and seam allowances to inside, pressing in place.  For pointed corners, fold corners diagonally.  For rounded corners, pull ease stitches to ease fullness, notch curves if you have not already done so. Press.
Resources
Pockets: Self-faced Patch Pocket

HOMESTOREARTICLESFREE VIDEOSFAQ's

4 Free Getting-Started Gifts with Subscription

You'll receive:
  • Instructions for this 'Pretty in Peach Princess Jacket' design 
  • Instructions for the Color-Blocked T-Shirt
  • 4-pg. essential Guide to Sewing Notions
  • Drawing tool - Designer's Companion (with 1st order)

You will receive an email asking your to confirm your subscription. (Watch for this in your email Inbox.  If it's not there, check your Junk/Spam folder).  Then you'll be directed to the Subscription Gifts page where you can choose 1 or more of the Welcome Gifts (see revolving carousel below).

No Spam - Total Privacy - Unsubscribe at any time

To see what the Designer's Companion is used for and how it is different from the Designing Stylus, please click here.
PO Box 5698, Eugene, OR 97405 USA     (541)344-0422     info@surefitdesigns.com   Copyright © 2010-2015, Ranita Corporation, Eugene, OR  
**Note** You are currently in the SFD Learning Center.  All links below will take you back to the main Sure-Fit Designs website and will open up in a new browsing window.
Quick Links
Customer Care
Orders